Installation steps for the Alligator Tail Cowl STREET750 - including how to route the wiring clear
Installation steps for the Alligator Tail Cowl (with LED taillight) for STREET750. Covers, with photos, removing the stock seat, setting the cowl and securing it with 4 bolts, routing the wiring clear and connecting the taillight wiring, and refitting the seat.
- How to fit the cowl, with the taillight installed, over the rear frame
- Securing with 4 bolts and taking care not to pinch the wiring
- Checking the wiring is routed clear and connecting the taillight wiring
The Alligator Tail Cowl is a tail cowl with an LED taillight that fits over the rear frame of the STREET750. The stock seat can be installed as is.
This page covers removing the stock seat, securing the cowl, connecting the taillight wiring and refitting the seat, in the order of the photos in the instructions.
01 Installation steps
-
Remove the stock seat.
-
Fit this product, with the taillight installed, over the rear frame.
Take care not to pinch the wiring.
-
Secure it at 4 points with bolts.
-
After confirming the wiring is routed clear as shown in the photo, connect the taillight wiring.
-
Fit the seat.
After installation, be sure to check that all bolts are tight and that the taillight works. Descriptions of the tools used and general wiring procedures are omitted. Due to individual differences between bikes, some adjustment or ingenuity may be required. If you are unsure about installing it yourself, please be sure to have the work done by someone with the proper knowledge or by a custom shop. If you have any questions, please contact us via our contact form.
Products covered in this article
*Installation is at your own risk. If you're unsure about doing the work yourself, we recommend consulting your local motorcycle shop.
*The content and photos reflect the time of writing. Please check each product page for current specifications, fitment and stock.