Assembly Diagram for the King Seat (SR400/500 up to '08)
The assembly diagram for the King Seat for the SR400/500 (up to '08). It shows the bracket and bolts to transfer from the stock seat and how they sit relative to the mount rubbers. The seat mounts the same way as stock.
- Parts to transfer from the stock seat (bracket and bolts)
- How the bracket, mount rubbers, and bolts fit together
- Mounting the same way as stock
The King Seat is a tuck-and-roll seat for the SR400/500 (up to '08). It comes in two colors, black/black and black/white, and both install the same way.
Based on the assembly diagram, this page covers the parts you need and how the installation works.
01 Assembly diagram
Attach the bracket and bolts removed from the stock seat to the underside of this seat. The red arrows in the diagram show roughly where they go. The seat mounts the same way as stock.
To install the King Seat, you need the bracket and bolts from the stock seat. Remove them from the stock seat and reuse them.
02 Before use
Always check that all fasteners are tight before use. If you notice anything unusual during use, stop using it immediately and inspect it. If you are unsure about the installation, be sure to have it done by someone experienced or by a custom shop. For any questions, please reach us through our contact form.
Products covered in this article
Related articles
*Installation is at your own risk. If you're unsure about doing the work yourself, we recommend consulting your local motorcycle shop.
*The content and photos reflect the time of writing. Please check each product page for current specifications, fitment and stock.