Installing the Seat Rubber Spacer (SR400/500 '78-'08)
Installation steps for the Seat Rubber Spacer for the SR400/500 ('78-'08). Photos show how to remove the stock seat, add this product to the stock seat mounting rubber at the front of the frame, and which way the collar faces.
- Removing the stock seat
- Adding it to the stock seat mounting rubber at the front of the frame
- Checking the collar orientation
The Seat Rubber Spacer is used when fitting the GOODSEAT "SLENDER" to the SR400/500 ('78-'08) (original name: SEAT RUBBER SPACER for GOODSEAT SLENDER).
This page covers removing the stock seat, adding the spacer to the seat mounting rubber at the front of the frame, and fitting the seat.
01 Installation steps
Remove the stock seat, and add this product to the (stock) seat mounting rubber at the front of the frame.
-
Remove the stock seat and locate the (stock) seat mounting rubber at the front of the frame.
-
Lay out this product. Refer to the photo for the collar orientation.
-
Add this product to the (stock) seat mounting rubber.
-
Fit the seat.
Pay attention to the collar orientation (see photo).
Always check that all fasteners are tight before use. If you notice anything unusual during use, stop using it immediately and inspect it. If you are unsure about the installation, be sure to have it done by someone experienced or by a custom shop. For any questions, please reach us through our contact form.
Products covered in this article
Related articles
*Installation is at your own risk. If you're unsure about doing the work yourself, we recommend consulting your local motorcycle shop.
*The content and photos reflect the time of writing. Please check each product page for current specifications, fitment and stock.