Installing the Saddle Seat Mount Kit (Grasstracker up to '07): From Relocating the CDI to Final-Tightening the Seat
Installation steps for the Saddle Seat Mount Kit for the Grasstracker (up to '07). Following the chapter order, we cover fitting the seat brackets, moving the CDI to the CDI plate, securing the seat mount bracket, and final-tightening the front of the seat.
- Moving the CDI to the included CDI plate
- How to secure the front and rear of the seat mount bracket
- Final tightening aligned with the seat's rear damper position
The Saddle Seat Mount Kit is a bracket kit for fitting a saddle seat to the Grasstracker (up to '07). The Grasstracker kit for the GOODSEAT "SADDLE" installs with the same steps.
Following the chapter order of the original manual, this page covers fitting the brackets to the seat, relocating the CDI, securing the seat mount bracket, and final-tightening the seat.
01 Fitting the seat brackets and relocating the CDI
-
Chapter.01 Fit the included seat brackets to the seat as shown in the photo.
-
Chapter.02 Remove the CDI.
-
Chapter.03 Remove the CDI mounting plate.
-
Chapter.04 Install the included CDI plate.
-
Chapter.05 Install the CDI.
02 Installing the seat mount bracket
-
Chapter.06-1 Set the included seat mount bracket in place as shown in the photo.
-
Chapter.06-2 Set the included seat mount bracket in place as shown in the photo.
-
Chapter.07 Lay out the included M6 cap bolts and large washers.
-
Chapter.08 Secure the front of the seat mount bracket as shown in the photo.
-
Chapter.9-1 Secure the rear of the seat mount bracket with the included bolt and nut.
-
Chapter.9-2 Secure the rear of the seat mount bracket with the included bolt and nut.
03 Securing the seat
-
Chapter.10 Lay out the included bolts and nuts.
-
Chapter.11 Secure the front of the seat.
Final-tighten the front of the seat at the position where the seat's rear damper rests on the frame tube.
Always check that all fasteners are tight before use. If you notice anything unusual during use, stop using it immediately and inspect it. If you are unsure about the installation, be sure to have it done by someone experienced or by a custom shop. For any questions, please reach us through our contact form.
Products covered in this article
Related articles
*Installation is at your own risk. If you're unsure about doing the work yourself, we recommend consulting your local motorcycle shop.
*The content and photos reflect the time of writing. Please check each product page for current specifications, fitment and stock.