Installing the Shift Change Support (APtrikes125)
We explain how to install the Shift Change Support for the APtrikes125. With photos, we follow the steps in order, from removing the left cover to securing the support base and plate and the final tightening.
- Where the cover to remove before work is located
- How to secure the support base with a U-bolt
- How to assemble the stock support rubber and plate
The Shift Change Support is a chassis part made specifically for the APtrikes125.
This page shows the steps from removing the left cover under the seat to fitting the support base and support plate and securing each bolt and nut.
01 Remove the left cover
First, remove the left engine cover under the seat.
02 Fit the support
-
Fitting the support base: Set the support as shown in the diagram and secure it to the engine mount with the included U-bolt.
-
Fitting the support plate: Set the stock support rubber in place and secure the plate over the top of it.
-
Securing the bolts and nuts: Secure each bolt and nut, and the installation is complete.
Explanations of the tools used and general wiring work are omitted. Due to variation between individual bikes, some minor adjustment or improvisation may be needed. If you're unsure about the installation, always have it done by someone knowledgeable or a custom shop. For questions or anything unclear, please contact us via the contact form.
Products covered in this article
Related articles
*Installation is at your own risk. If you're unsure about doing the work yourself, we recommend consulting your local motorcycle shop.
*The content and photos reflect the time of writing. Please check each product page for current specifications, fitment and stock.