Installing the Side Mount Headlight KIT and Upper Fork Cover KIT (RH975/Nightster)
Installation steps for the Side Mount Headlight KIT and Upper Fork Cover KIT for the RH975/Nightster. We explain removing and refitting the top triple clamp, fitting the O-rings and fork covers, securing the headlight case and checking that the light works.
- Removing and refitting the top triple clamp and fitting the fork covers
- A note on the orientation of the fork cover with headlight bracket
- Moving the stock headlight into the case and checking that it lights
The Side Mount Headlight KIT mounts the RH975/Nightster's headlight on the side of the fork. The Upper Fork Cover KIT finishes the fork area below the top triple clamp with covers and also serves as the mounting base for the headlight kit.
This page first covers installing the Upper Fork Cover KIT, then explains the steps for installing the Side Mount Headlight KIT. If you're fitting only the fork cover kit, you're done after the first half.
01 Before you start
Installation requires removing and refitting the top triple clamp. Jack up the bike and secure it.
02 Fitting the upper fork covers
-
Remove the cowl and headlight and loosen each bolt on the top triple clamp.
-
Remove the top triple clamp. Be careful not to scratch the tank or other parts.
-
Set the O-rings and fit the fork covers.
On the version with the headlight bracket, pay attention to the orientation of the fork cover. Fit it so the bend of the bracket faces inward. Secure the triangular light bracket with a bolt from the outside.
-
Set an O-ring on top of the fork cover as well.
-
Set the top triple clamp in place and secure each bolt.
That completes the installation of the Upper Fork Cover KIT (Part No. GW-6052).
03 Fitting the Side Mount Headlight KIT
From here on are the installation steps for the Side Mount Headlight KIT.
-
Fit the bracket that holds the cables and harness.
-
Set the stock headlight in the light case.
-
Secure the headlight case to the fork cover with the light bracket attached.
-
Connect the headlight connector and check that it lights up.
Use thread-locking compound as needed during installation. Explanations of the tools used and general wiring work are omitted. Due to variation between individual bikes, some minor adjustment or improvisation may be needed. If you're unsure about the installation, always have it done by someone knowledgeable or a custom shop. For questions or anything unclear, please contact us via the contact form.
Products covered in this article
Related articles
*Installation is at your own risk. If you're unsure about doing the work yourself, we recommend consulting your local motorcycle shop.
*The content and photos reflect the time of writing. Please check each product page for current specifications, fitment and stock.