Assembly Diagram for the Taillight Kit (250TR)
The assembly diagram for the Taillight Kit for the 250TR. It shows the two bolt locations that secure the tail base to the rear frame and where the collar goes. This reference applies to all Miller and Lucas taillight kits.
- The two points where the tail base attaches to the rear frame
- Location of the bolt secured with a collar in between
- Bolt and washer orientation
The Taillight Kit for the 250TR mounts the taillight and license plate on a tail base, which is then secured to the rear frame. The Miller STOP, Miller 38ET, Lucas MT110, Lucas L525, and Lucas 477 taillight kits all share the same mounting structure.
Based on the assembly diagram in the original, this page shows where the tail base is secured and how the parts go together.
01 Assembly diagram
The tail base is secured to the rear frame with two bolt and washer sets. The red lines in the diagram show the holes on the rear frame where each bolt goes.
- Bent tip of the tail base: secured to the upper hole on the rear frame with a bolt and washer
- Center of the tail base: pass the bolt and washer through, place a collar under the tail base, and secure to the lower hole on the rear frame
02 Installed
After installation, check that everything is tight and the taillight works. If you are unsure about the installation, be sure to have it done by someone experienced or by a custom shop. For any questions, please reach us through our contact form.
Products covered in this article
Related articles
*Installation is at your own risk. If you're unsure about doing the work yourself, we recommend consulting your local motorcycle shop.
*The content and photos reflect the time of writing. Please check each product page for current specifications, fitment and stock.